All Kickster Goals come with:
Pre-connected Base Frame
Upright Poles
Flexi-Post Net
Ground Anchors (4 Pegs Included. Sandbags for Astroturf can be purchased separately)
Unfold the Base Frame and clip together pushing each section together until the connecting clip snaps into place.
NOTE: THE BACK BAR OF THE BASE FRAME HAS A GENTLE UPWARD CURVE AT THIS STAGE- THIS IS NORMAL AND PART OF THE DESIGN.
If using the Kickster PRO 3600 extend each telescopic Upright side pole.
If using the Kickster PRO 2000 Unfold the pre-connected Upright poles.
If using the Kickster PRO 2000 Unfold the pre-connected Upright poles.
Then slide each Upright pole into the base corners.
Take the Top Pin attached to the left or right corner of the goal mouth (it doesn’t matter which) and insert into the top of the corresponding Upright Pole.
Then hook on the bottom of that Post through the locating eyelet.
Take the other Top Pin and repeat this process on the other side of the goal
Secure the net using the pre-attached Velcro tabs, wrapping each one around the Frame.
Secure the frame to the playing surface with the ground pegs provided.
If using on a hard surface, fill the two bags provided with sand and place behind the Posts, in the same position which is shown here for the pegs.
You’re ready to play- wherever and whenever you like.
